Honeywell HTR1, Installation And Operating Manual

Page: 26 / 44

Rev B 26 Document 800-00759
11/07
System Setup
Note You can program the VCR when no video camera is connected to the system.
In this case the message
NO VIDEO DETECTED
displays on the screen.
Navigating the Menu Screen
Table 3-2 Menu Screen, Default Settings Shown
Use the following tools and symbols to navigate the HTR 1 screens.
Cursor
The current position of the Cursor is shown in reverse video on the menu screen. In the
example below, the cursor is on 2.
Tool-Tip Text
When you hover your cursor over a field, the tool-tip appears in the bottom line of the
screen.
These tool-tips always appear in
Title line (up to 20 characters)
Camera trigger status indicators
Daily timers
1-4
Record START delay
Record STOP delay
Current Time and Date
= Parameter is enabled
= Parameter is disabled
For example, Bus ID
XXXXXXXXXXXXXXXXXXX
10:09:07 DT 1/ 7/2008
BRK STP TRN
FSH ARM 00 00 EP
MPH
12:00 12:00
12:00 12:00
12:00 12:00
12:00 12:00
Daylight Saving Time on/off
GPS Position (latitude/longitude)
GPS Direction
Cursor
Tool-Tip (explains cursor field)
Bus ID String
Bus ID on/off
Reset/restore defaults
Record Speed (EP/SP)
Record Mode
Speed Units (MPH/KPH)
DST Indicator
BUS 2 3
REVERSE VIDEO