Honeywell AlarmNet GSMBR, Installation And Setup Manual, Page: 41 / 64

Section 4: Registration
4-3
Replacing an existing module using the programming tool
Enter PIN#
This prompt appears after pressing the [Shift} and down arrow [ ↓ ] on
the 7720P.
NOTE: If it is necessary to exit registration mode, press ESC.
Enter a 4-digit alphanumeric PIN number provided by your central
station, your dealer or an authorized AlarmNet representative.
Press the [Enter] key.
Registering …
The registration message is sent and the unit waits for
acknowledgement.
Registration
SUCCESS
If the PIN is valid, the new communications module is registered and
the old unit unregistered. Additionally, AlarmNet sends a
substitution alarm to the central station.
Registration BAD
If you entered an invalid PIN, the appropriate message is displayed
depending on which account number is being replaced (see above for
exact wording). The registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be sent to the
central station.
Register through AlarmNet Direct Website
If you have programmed the module through AlarmNet Direct, you must then transfer the
data to the module, and register the module.
To do this, please go to:
https://services.alarmnet.com/AlarmNetDirect/
Log in and follow the on-screen prompts.
If you are not signed up for this service, click on “Dealer Signup” from the login screen to set
up your dealer account.
You will be instructed how to proceed upon completing the sign-up form. Only one sign-up
per dealer is required. Once an initial user is established, additional logins may be created
by that user.
Please have the following information available when programming the device:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on outside of box and on label inside
module).
Once module is registered, you may log out of the AlarmNet Direct website.