Honeywell AlarmNet GSMBR, Installation And Setup Manual, Page: 11 / 64

Section 2: Mounting and Wiring
2-3
COMMUNICATIONS
MODULE
VISTA CONTROL PANEL
iGSMBR-005-V0
GND
GND
ECP DATA IN
2
1
4
5
TB1
TRANSFORMER
AC INPUT 2
AC INPUT 1
J1
BATTERY
+12V AUX ECP (+) VOLTAGE INPUT
3
DATA IN
ECP DATA OUT
6
DATA OUT
BLK
YEL
RED
GRN
Figure 2-2. Wiring a VISTA for ECP Mode or 4204 Modes
To wire the module to a LYNXR-I, see Figure 2-3 . Refer to the LYNXR-I Installation and
Setup Guide.
COMMUNICATIONS
MODULE
(OPTIONAL) REQUIRED
FOR 24-HR BACKUP
iGSMBR-006-V0
GND
Z3 OR DATA OUT
Z1/Z2 OR DATA IN
ECP (+) VOLTAGE INPUT
RED
BLK
GRN
YEL
RED
BLK
GRN
YEL
6
3
5
4
4-WIRE CABLE (N4632-4)
1
2
TB1
LRR/IP COMMUNICATIONS PORT
LYNXR-I CONTROL PANEL
NC
+12 VDC
GND
D
ATA
I
N
D
A
T
A
OUT
DO NOT CONNECT THE COMMUNICATIONS MODULE BACKUP
BATTERY OR TRANSFORMER WHEN USING WITH LYNXR-I
NOTE
LYNX
SUPER HIGH
CAPACITY
BATTERY
LYNX
STANDARD
CAPACITY
BATTERY
Figure 2-3. Wiring a LYNXR-I for ECP Mode
Wiring for Zone Trigger Mode
You can use a security system's output (such as a bell output or voltage trigger), to trip the
Z1/Z2 zone on the communications module and thereby generate a report to the monitoring
station. The trigger can be a positive voltage, a ground, or a voltage change taken from a
security system zone that is supervised with an EOLR. Depending on which triggering
method is used, ensure the communications module Z1/Z2 zone is properly programmed.
•
For positive voltage tripping (V+) of zone Z1/Z2, the voltage must be within 2.0V-14V.
Trigger levels above this range may cause permanent damage to the unit. Trigger levels
below this range result in unreliable operation.
•
For ground voltage tripping (V–) of zone Z1/Z2, the voltage must be less than 1.0V.