Honeywell ADEMCO VISTA-120, Installation And Setup Manual

Page: 77 / 114

Section 6 - Scheduling Options
6-7
Holiday Schedule Programming
After entering Scheduling Menu Mode, press [0] until the “Holidays ?” prompt appears.
PROMPT EXPLANATION
Holidays ?
1 = YES 0 = NO 0
Enter 1 to program holiday schedules.
HOLIDAY NUMBER ?
01-16,00=Quit 01
Enter the 2-digit holiday number (01-16) to be programmed and press [
✳
] to accept entry.
Enter 00 + [
✳
] at the “Holiday Number?” prompt to quit the holiday menus and display the “Quit ?” prompt.
01 ENTER DATE
00/00
The cursor is now positioned on the tens of months digit. Enter the appropriate month, then press [
✳
] to
proceed to the day field.
Enter the appropriate day for the holiday.
Press [
✳
] to accept the entry.
Part ? 12345678
Hit 0-8 x x
Holidays can be set for any partition, as follows. Press [0] to turn all partitions on or off, or use keys 1-8 to
toggle the letter “x” under the partition to which this holiday will apply.
Press the [
✳
] key when all desired partitions have been assigned.
The “Holiday Number?” prompt is displayed again. Repeat the procedure for each holiday to be
programmed.
Quit ?
1 = YES 0 = NO 0
Enter 0 at the “Quit ?” prompt to return to the main menu choices and continue programming.
Enter 1 to quit Scheduling Menu Mode.
Time Driven Events
These are the schedules used to activate outputs,
bypass zones, etc. based on a time schedule. There are
20 of these events that may be programmed for the
system, with each event governed by the previously
defined time periods.
The actions that can be programmed to automatically
activate at set times are: relay commands, arm/disarm
commands, zone bypassing commands, and open/close
access conditions.
Time-Driven Events Worksheet
The following worksheet is an example of the worksheet
found in the
Programming Guide. Fill out the
worksheet using the steps outlined below.
Sched Time Days Action Action Activation
Num. Period M T W T F S S H Desired Specifier Time
1
2
3
1. Enter the schedule number (01-20) and time
period number (01-20),
and note the day of the
week the action is desired.
2. Enter the code for the desired action and
action specifier.
The action codes represent the
events that are to take place when the scheduled
time is reached.
Each action also requires an action specifier, which
defines what the action will affect (relay, relay
group, partition, zone list, user group). The action
specifier varies, depending on the type of action
selected.
The following is a list of the Action Codes (desired
actions) used when programming Time-Driven events.