Honeywell ADEMCO VISTA-120, Installation And Setup Manual

Page: 48 / 114

VISTA-120 Installation and Setup Guide
4-4
Zone Index
The VISTA-120 has 128 physical zones, as well as
supervisory zones for relays, ECP devices (devices
which communicate through the keypad terminals), and
system troubles.
The zones are designated as follows:
Zone Function
1 2-wire Smoke Detectors (if used)
5 Audio Alarm Verification (if used)
7 Keyswitch (if used)
8 Latching-Type Glassbreak Detectors (if used)
1-9 Basic Wired Zones
1-128 5800 Series Wireless Devices
10-128 Polling Loop Devices
995
✳
+ 1 Panic
996 # + 3 Panic
999
✳
+ # Panic
ZONE #
RANGE ZONE
FUNCTION
ACTUAL ZONE
001 - 128 Protection
zones As indicated
601 – 696 Relay
Supervisory
Zones 6 + 2-digit relay number (e.g.
relay number 03, if
supervised, is zone 603
NOTE: Relay supervision
should be used only for
relays on 4204CF modules.
800 - 830 ECP Device
Supervisory
Zones 8 + 2-digit Device Address,
e.g., Device Address 01, if
supervised, is zone 801. The
4286 VIP module is zone 804
(since its Device Address must
be set to 4).
988, 990, &
997 System
Supervisory
Zones 988: 2
nd
Wireless Receiver –
not receiving signals
990: 1
st
Wireless Receiver –
not receiving signals
997: Polling Loop (short
circuit)
995, 996,
999 Keypad
Panics 995: 1+
✴
panic (A key)
996: 3 + # panic (C key)
999:
✴
+ # panic (B key)
Communication Programming Guide
Field # Low Speed Contact ID High Speed Express
*46, *48 Choose transmission speed and
frequency No effect No effect No effect
*52, *53 Send as either 4+2 or expanded No effect No effect No effect
*79, *80 Enables alarm restores Enables alarm
restores Enables alarm restores Enables alarm restores
*49 Add checksum digit No effect Add checksum digit No effect
*50 Sescoa/Radionics. Selects fixed digit
time instead of fixed interdigit. No effect No effect No effect
NOTE: Low Speed will not send 3+2 messages. Zone ID digit is suppressed.
Communication Defaults
*45 PRIMARY FORMAT [1]
ADEMCO Contact ID
*46 LOW SPEED FORMAT (Prim) [0]
ADEMCO Low Speed
*47 SECONDARY FORMAT [1]
ADEMCO Contact ID
*48 LOW SPEED FORMAT (Sec.) [0]
ADEMCO Low Speed
*49 CHECKSUM VERIFICATION [0] [0]
No checksum Primary Secondary
*50 SESCOA/RADIONICS SEL. [0]
Radionics
*51 DUAL REPORTING [0]
no
*52 STANDARD/EXPANDED REPORT FOR PRIMARY
[0] [0] [0] [0] [0] [0]
standard
Alarm Rstr Bypass Trbl Opn/Cls Low Bat
*53 STANDARD/EXPANDED REPORT FOR SECONDARY
[0] [0] [0] [0] [0] [0]
standard
Alarm Rstr Bypass Trbl Opn/Cls Low Bat