Honeywell 6808, Installation And Operation Manual

Page: 119 / 170

6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
119
System Operation
10.4.14 System Information
Press 8 from the Main Menu to view the panel model and serial number and system version number and date. Press the left arrow to
return to the main menu.

About Panel
Press 1 to access About Panel to view the panel model, serial number and system version number and date.

Send/Receive firmware updates
The 6808 has the ability to be updated in the field. The latest 6808 Firmware Update Utility can be downloaded from the Silent Knight
Web Site, www.silentknight.com. Once a panel has been updated using the Firmware Update Utility, you can use Send/Receive firmware
updates to propagate the firmware to the other panels in the network.
1. Press 2 to send a firmware update or press 3 to receive a firmware update from the System Information menu. Available panels are
listed in the menu.
2. Use the up or down arrow key to select a panel to send/receive an update to/from. Press ENTER to start the update process.

Ethernet Info
1. Press 5 from the System Information menu for Ethernet Information.

AlarmNet Info
1. Press 6 from the System Information menu for AlarmNet Info
2. Cell Strength: 0 to 100%
3. Status: Registered/Not Registered

AlarmNet Temporary PIN
Press 7 from the System Information menu for AlarmNet Temporary PIN. This is used in case the FACP is replaced on the CCP.
10.5 Operation Mode Behavior
The control panel can be in one or more of seven conditions at any given moment: Normal, Alarm, Prealarm, Supervisory, Trouble,
Silenced, and Reset. Table 10.1 describes the behavior of the panel in each of these modes.
When looking at the LCD, the screen will display FIRE for the “Fire System”, CO for the “CO System”. The highest priority event will
display first and include the event count (see Figure 10.4).
Press the down arrow to view the location and type of alarm, supervisory, or trouble. If the panel is programmed to Auto Display Event,
information describing the highest priority active event will display on the first two lines. The 3 and 4th line will show the status of
which event types are active for each system (fire and CO). Auto Display Event activates after two minutes of annunciator inactivity.
Figure 10.4 Highest Priority Event Display
Figure 10.5 This Screen will display when more that 3 event types are active