Honey Bee Grain Belt Plus, Owner'S Manual

Page: 169 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Problem Possible Cause Solution
Pump
Oil running hot. Excessive oil going over relief.
Faulty pump or motor(s).
Hot oil dump on right-hand
deck motor not functioning
properly.
Draper too tight. Clean or replace relief
cartridge.
Repair or replace.
Clean or replace.
Adjust draper tension.
Oil leaking between
pump and gear box. Silicone/Gasket seal broken.
No silicone between pump and
gear box. Re-seal pump.
Apply silicone.
Pump vibrating. Faulty universal joint bearings.
Incorrect angle on drive-line. Replace.
Verify that rotating pump
mount assembly is in correct
alignment for combine make.
Low Pressure Supply line not connected Connect supply line.
Raising Header
Header will not lift. Inadequate combine lift
capacity. Check system pressure.
Add hydraulic cylinder to
feeder house. (*Refer to
Combine Manual.)
Reel
Reel will not raise. Hydraulic couplers don’t match.
Hydraulic couplers not
engaged.
Faulty combine hydraulics. Install correct couplers.
Re-couple properly.
Refer to Combine Manual.
Reel raises slowly. Elbow in master cylinder too
tight.
Hydraulic couplers not
engaged. Loosen fitting.
Re-couple quick couplers.
Rev. 07 - 07/29/08 167