Honey Bee Grain Belt Plus, Owner'S Manual

Page: 114 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Check and remove any buildup of material from draper deck runners. If
necessary, split draper at connector bar to gain access to the inside of the
deck.
To re-install drive roller, reverse above procedure. (Ensure that extruded “V” on back of draper
is properly seated into recessed “V” on drive roller; adjust tension.)
Feeder deck Idler Roller Removal
Refer to Illustration 10-17: Subframe - Idler Roller, Illustration 10-16: Idler Axle and Bolt -
Close Up, and Illustration 10-18: Idler Roller - Center Axle, page 113.
1. Separate the sub-frame from the header.
2. Relieve tension from draper with quick release tension lever. (refer to Draper Tension
section in this chapter)
3. Remove connector bar from draper. Open draper to expose idler roller.
4. Remove the Outside wind guard to access the idler axle bolt.
Rev. 07 - 07/29/08 112
Illustration 10-17: Subframe - Idler Roller Illustration 10-16: Idler Axle and Bolt -
Close Up