Honda iGX440, Owner'S Manual

Page: 3 / 72

BEFORE OPERATION CHECKS
FEATURES
IS YOUR ENGINE READY TO GO?
Check the General Condition of the Engine
Check the Engine
OIL ALERT SYSTEM
Engine type Oil Alert action
Engine type Oil Alert action
If the ECM is set to stop the engine:
If the ECM is set to continue engine operation:
ENGLISH
RECOIL STARTER TYPES
CHOKE LEVER MANUAL START LEVER
ELECTRIC STARTER TYPES
3
For your safety, and to maximize the service life of your
equipment, it is very important to take a few moments before you
operate the engine to check its condition. Be sure to take care of
any problem you find, or have your servicing dealer correct it,
before you operate the engine.
Improperly maintaining this engine, or failure to
correct a problem before operation, can cause a
malfunction in which you can be seriously hurt or
killed.
Always perform a pre-operation inspection before
each operation, and correct any problem.
Before beginning your pre-operation checks, be sure the engine is
level and the engine switch is in the OFF position.
Always check the following items before you start the engine:
Look around and underneath the engine for signs of oil or
gasoline leaks.
Remove any excessive dirt or debris, especially around the
muffler and recoil starter.
Look for signs of damage.
Check that all shields and covers are in place, and all nuts, bolts,
and screws are tightened.
Check the fuel level (see page ). Starting with a full tank will
help to eliminate or reduce operating interruptions for refueling.
Check the engine oil level (see page ). Running the engine
with a low oil level can cause engine damage.
If the oil level in the crankcase falls below a safe limit, the Oil
Alert system will either shut off the engine or issue a warning.
However, to avoid the inconvenience of an unexpected
shutdown, always check the engine oil level before startup.
Check the equipment powered by this engine.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
be followed before engine startup.
Check the air filter element (see page ). A dirty air filter
element will restrict air flow to the carburetor, reducing engine
performance.
The Oil Alert system is designed to prevent engine damage
caused by an insufficient amount of oil in the crankcase. Before
the oil level in the crankcase can fall below a safe limit, the Oil
Alert system will either shut off the engine or issue a warning.
Refer to the instructions provided by the equipment manufacturer.
If you continue to operate the engine after the Oil Alert system has
been activated, you can damage the engine.
If the engine stops and/or will not restart, check the oil level (see
page
) before troubleshooting in other areas.
Electric start
Recoil start The engine continues to operate.
The engine will not restart.
The LED on the ECM blinks twice.
The engine continues to operate.
The engine will not restart.
Electric start
Recoil start The engine stops.
The engine will not restart.
The LED on the ECM blinks twice.
The engine stops.
The engine will not restart. 1.
2.
3.
4.
1.
2.
3.
4.
7
8
9, 10
8
‘‘Oil Alert is a registered trademark in the United States’’
07/06/21 11:41:58 32Z3S600_003