70
STARTING THE ENGINE
The power will not be turned ON
unless the Honda Smart Key is
authenticated.
4. Push the start/stop switch.
When the boat is mounted with the
two outboard motors, push the all
engine start switch.
• The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
5. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
If water does not flow out, or if
steam comes out, stop the engine.
Check to see if the screen in the
cooling water intake port is
obstructed and remove foreign
materials if necessary. Check the
cooling water check hole for
clogging. If water still does not flow
out, have your outboard motor
checked by an authorized Honda
outboard motor dealer. Do not
operate the engine until the
problem has been corrected.
COOLING WATER CHECK HOLE
COOLING WATER INTAKE PORT
(each side)
42ZVL600.book 70 ページ ２０１８年７月１９日 木曜日 午前９時６分
