10
EN: BREAD MAKER |
Instruction Manual
start/stop button the program continues automatically after a 10-minute pause. This function does not apply to programs
7,8,9,11,12,13,14 or 15.
Ending a program
When the baking process has been completed, ten acoustic signals are issued and the display indicates 0:00. At the end of
the program the appliance automatically changes to a warming mode for up to 60 minutes. In this mode, warm air circulates
inside the appliance. You can prematurely terminate the warming function by keeping the Start/Stop button pressed until
two acoustic signals are heard. The “keep warm” phase does not apply to program 9,10,11,12,13 or 14.
WARNING:
Before opening the appliance lid, pull the power plug out of the wall socket. When not in use, the appliance should
never be plugged in!
Taking out the bread.
When taking out the baking pan, always use pot holders or oven gloves. Hold the baking pan tilted over a grid and shake
lightly until the bread slides out of the baking pan. If the bread does not slip off the kneading paddles, carefully remove the
kneading paddles using the enclosed kneading paddle remover.
NOTE: Do not use any metal objects that may lead to scratches on the non-stick coating. After removing the bread,
immediately rinse the baking pan with warm water. This prevents the kneading paddles from sticking to the driving
shaft.
Tip:
If you remove the kneading paddles after the last kneading of the dough, the bread will remain intact when you remove
it from the baking pan.
• Briefly press the Start/Stop button, to interrupt the baking process or pull the power plug out of the wall socket.
• Open the appliance lid and take out the baking pan. You can take the dough out with floured hands and remove the
kneading paddles.
• Replace the dough and close the appliance lid.
• Push the plug back into the wall socket and press the Start/Stop button. The baking program is continued. Let the bread
cool for 15-30 minutes before eating. Before cutting bread, make sure that no kneading paddle is still in the baking pan.
WARNING:
Do not attempt to start operating the bread maker, before it has either cooled down or warmed up. If the display shows
“HHH” after the program has been started, it means that the temperature inside of bread pan is too high. You should stop the
program and unplugged the power outlet immediately. Then open the lid and let the machine cool down completely before
using again If the display shows “LLL” after the program has been started, it means that the temperature inside of bread pan
is too lower it cannot work, as the ingredient of food will be frozen, if work, the bread maker will be damaged. You should
stop the program and unplugged the power outlet immediately , remove it to the warmer environment until the ingredient
of food will not be frozen then it can work. If the display shows “EE0” after you have pressed Start/Stop button, switch off
the main switch and disconnect the mains plug, then insert the mains plug again and switch on the main switch, if the error
message is still displayed, please contact Customer service.
CLEANING AND CARE
Warning:
Pull the power plug out of the wall socket each time and allow the appliance
to cool down. Protect the appliance against splashing water and moisture, as these could lead to an electric shock.
Please also observe the safety instructions.
IMPORTANT:
The parts and accessories of the appliance should not be washed in a dish washing machine.
Casing, lid, baking chamber
Remove all particles left behind inside the baking area using a wet cloth or a slightly wet soft sponge. Wipe the casing and
the lid too with a wet cloth or sponge. Make sure that the inside area is fully dry. For easy
cleaning, the appliance lid can be
