❏
6. Install the wing rod and the anti-rotation pin into the
right wing.
❏
7. Carefully slide the left wing all the way onto the rod and
into the CenterCore wing rib until it stops.
❏
8. Use two more #4 x 3/4" [19mm] screws to hold the two
wing halves together.
❏
9. Cut and bend a 2mm x 6"[150mm] pushrod to match
the sketch above. Make a left and a right pushrod.
❏
10. Cut a servo arm as shown above and use a Hobbico
Servo Horn Drill (or a #48 or 5/64" [2mm] drill bit) to enlarge
the servo arm holes. Install the arm on the servo. Install a
clevis and a clevis retainer on the threaded end of the
pushrods. Slide the unthreaded end of the pushrod into your
servo arms and install Faslinks to secure them.
10
Summary of Contents for NexStar ARF
Page 31: ...31 Correct Angle Rods Fin...
Page 32: ...32...
