HoB HOBLink, Administration Manual

Page: 60 / 83

Configuring HOBLink VPN Gateway HOBLink VPN Gateway
60 Security Solutions by HOB
5.12.2 VPN Status
This allows you to check the connections of the machines where the
HOBLink VPN Gateway is running.
Figure 38: VPN Status
The information shown on this screen is divided into two parts:

The panel on the left contains the peers connected to the gateway (with the
channel and tunnels of each connection).

The panel on the right contains the information about the entry selected in the
panel on the left.
If you completely extend the tree of a connection on the left, you can see its channel,
the tunnels established with this gateway and the inbound/outbound traffic with its
SAs.
When you select a peer on the left, some of its parameters are shown on the right.
You can see the type of the peer, the group the peer belongs to in this connection,
and its IP and assigned virtual IP.
When you select the channel of a peer on the left, parameters of the negotiation of
the connection, like IKE version, mode, encryption method, hash method,
authentication method and when the connection was created (and its duration) are
displayed on the right.
When you select a tunnel of a peer on the left, you can see the parameters about
the connection on the right, such as source and destination, configured service,
priority, type, mode, compression used and when the tunnel was created (and
duration).
It is possible to show the inbound/outbound traffic on the right by selecting Inbound/
Outbound SA Bundle of a tunnel on the left. You can also get information about
SA (both inbound and outbound) on the right by selecting the corresponding SA on
the left.
Click Refresh at the bottom of the screen to manually refresh the information on this
screen, or enable the Automatically refresh checkbox to refresh at a set time
interval.