HoB HOBLink, Administration Manual

Page: 54 / 83

Configuring HOBLink VPN Gateway HOBLink VPN Gateway
54 Security Solutions by HOB
5.11 VPN
HOBLink VPN Gateway enables a VPN to be established between multiple devices.
It needs to be installed on a host device, and the other participants, also known as
VPN Peers, in the communication network are then facilitated in their
communications by this host. The VPN host, peers and rules can be configured in
this section.
Figure 34: VPN
The entry fields for the VPN interface are as follows:
Name – enter the name of the gateway that hosts the VPN. This field is required
when the Initiator identification type set in the IKEv1/IKEv2 configuration is
FQDN
or
USER_FQDN
(see Section 5.8 Internet Key Exchange (IKE) on page 42 ).
IKE port – the UDP port number used for the IKE protocol. The value should be in
the range of
1–65535
. The default is
500
.
UDP encapsulation (NAT-T) Port – the UDP port number used for UDP
encapsulation. The value should be in the range of
1-65535
. The default is
4500
.
RPC port (Remote Procedure Call) – the port number used for remote procedure
calls. The value should be in the range of
1-65535
. The default is
13131
.
Default action – the default action for the VPN rules. The permitted actions that you
can select are
PASS
,
DROP
(default) and
REJECT
.
ESP substitute protocol number – (only used by Windows systems) the value
should be in the range of
1-255
. The default is
142
.
AH substitute protocol number – (only used by Windows systems) the value
should be in the range of
1-255
. The default is
143
.
IPCOMP substitute – (only used by Windows systems) the value should be in the
range of
1-255
. The default is
144
.