About the Anybus X-gateway CANopen
11
Doc.Id. HMSI-168-91
Anybus X-gateway CANopen - PROFINET
Doc.Rev. 2.10
2.6 Hardware Installation
Perform the following steps when mounting the gateway:
1.
Set the Node Address and the baud rate for the secondary CANopen network (see “Configura-
tion Switches” on page 9).
2.
Snap the gateway on to the DIN-rail (See “External View” on page 6)
The DIN-rail mechanism works as follows:
To snap the gateway
on
, first press it downwards (1) to compress the
spring in the DIN-rail mechanism, then push it against the DIN-rail as to
make it snap on (2).
To snap the gateway
off
, push it downwards (1) and pull it out from the
DIN-rail (2), as to make it snap off from the DIN-rail.
3.
Connect the gateway to the secondary CANopen network.
4.
Connect the gateway to the PROFINET network.
5.
Connect the power cable and apply power
1
2
1
2
Summary of Contents for AB7307
Page 55: ......
