RF-RKP - continued
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
42
•
The RF-RKP’s programmable options can be accessed as follows;
•
To get to the
RF Keypad Opts
(options) menu; select the
Devices Menu
. Then
RF Devs Menu
. Next select
the
RF Devs Options
. Scroll to
RF Keypad Opts
.
2
Wired Devices Menu
1
RF Devices Menu
•
When you select the
RF Keypad Opts
menu, you will see
RK1 RF Keypad
. Select this or scroll to the other
keypad by pressing
•
RK Contrast
, allows you to adjust the
keypad’s LCD contrast.
•
RK BackLight
, allows you to adjust the
keypad’s blue LCD light.
•
RK Audio Vol
, allows you to adjust the
keypad’s spoken messages.
•
RK Buzz. Vol
, allows you to adjust the
keypad’s buzzer volume.
•
RK LEDs
, when set to NO deactivates the
keypad’s status LEDs
•
RK Tamper
, when set to NO deactivates the
keypad’s tamper switch.
•
RK Entry/Exit
, allows activate or deactivate
the keypad’s Entry/Exit buzzer.
•
Finally,
RK Mon Sup
(Monitored Supervisory signal) is defaulted to
YES. When the device is ‘lost’ for >120 minutes a supervisory alarm is
flagged by the panel. This can be turned off by selecting NO. However,
we recommend that this feature is left as YES.
Note:
In
RF System Options
you can globally adjust the supervisory time by going to the
Sup. Time
(supervisory Time) menu.
4
RF SABB Opts
4
RF SABB Opts
4
RK1 Buzz. Vol
4
RK2 Buzz. Vol
1
RK1 Contrast
1
RK2 Contrast
5
RF Wand Opts
5
RF Wand Opts
1
RK1 RF Keypad
5
RK1 LEDs
5
RK2 LEDs
7
RK1 Entry/Exit
7
RK2 Entry/Exit
2
RK1 BackLight
2
RK2 BackLight
6
RF Keypad Opts
6
RF Keypad Opts
2
RK2 RF Keypad
6
RK1 Tamper
6
RK2 Tamper
8
RK1 Mon Sup
8
RK2 Mon Sup
3
RK1 Audio Vol
3
RK2 Audio Vol
#
next
!
!
!
Note:
Recording the site name via the RF-RKP’s microphone is not available
Note:
If there are no wired or RF keypads already assigned to the system and you then power-up an
RF-RKP within range, it will automatically attach itself to the system. It will detach itself if it is out of range for 10
minutes or there are no key-presses for 1 hour. To stop it from detaching, it will need to be Added & ID’ed.
If there has already been a wired or RF keypad assigned to the system you can still get an RF-RKP to
automatically attach so long as you are in Engineer mode and the tamper switch is open. Again, to stop it from
detaching, it will need to be Added & ID’ed.