HITEC Flash7, Instruction Manual, Page: 43 / 52

7 Channel 2.4 GHz Aircraft Computer Radio System 7 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu Section 6: Heli Programming Menu
82 83
F. Cond
The following features support flight condition programming in HELI mode:
Gyro
Revolution Mix
Swash > Throttle Mix
Throttle Curve
Pitch Curve
1. From the model menu, rotate the jog dial to highlight
“F.COND” and press the jog dial once to enter the flight
conditions menu.
2. Scroll to the flight condition to be configured and press the
jog dial to confirm your selection.
3. Press the jog dial again to activate the switch selection menu
(not applicable in “Normal” flight condition).
4. Scroll to select the switch that you will use to activate this
flight condition and press the jog dial to confirm your
selection.
a. If “NULL” is selected, the flight condition will be inactive.
b. If you selected a switch, the switch position menu will
appear.
- Scroll to highlight the switch position that you will use to
enable the flight condition. Press the jog dial to confirm
your selection.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate which flight
condition is active.
- Press the back button twice to return to the flight
conditions menu.
Heli Programming Menu
Thro Cut
Throttle Cut is a vital safety feature when flying glow or gas-powered models. This feature will command
the throttle servo to a preprogrammed position with a switch movement. You may choose to set the
servo to bring the engine to low-idle, or even shut it down.
To configure throttle cut:
If the more than one flight condition is concurrently enabled, the condition with the highest
number (per the table shown above) will be active. The field just below the model icon on the
Home screen indicates the active flight condition.
Warning
Note
Tip Tip
Tip Caution
5. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
6. Scroll to define the amount of time (0.0 to 10.0 seconds) to
transition the settings when this flight condition is enabled.
Press the jog dial to confirm your selection. This feature can
be utilized to prevent sudden control surface movements
when switching between flight conditions.
7. Press the back button to return to the flight conditions menu
and repeat steps 2-6 to define further flight conditions.
8. Press the back button twice to return to the model function
menu.
1. From the model menu, rotate the jog dial to highlight “THRO
CUT” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the throttle cut
menu.