7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 3: System Menu Programming
Section 3: System Menu Programming
40
41
Sensor
When used with the Optima series of telemetry capable receivers, the
Flash 7 has the ability to communicate a variety of information from
the airplane directly to the transmitter. Refer to Section Seven Using
the Telemetry System on page 97 for more information.
Spectra
The spectra menu is utilized to manage the interface between the Flash 7 transmitter and the receiver for
each aircraft. This includes specifying the receiver type, performing a range check, binding the receiver,
and specifying a frequency scan. All of these functions are covered in Section One: Introduction - Hitec
2.4GHz System. Please refer to pages 18 to 19 for complete information on the spectra menu.
Trainer cont.
9. To select which switch will be used for the trainer function
scroll down to the S/W field and press the jog dial to enter the
switch selection menu, press the jog dial again to activate the
switch selections.
10. Scroll to select a switch to activate the trainer function. Press
the jog dial to confirm your selection.
- If you choose the “NULL” option, the Trainer function will
remain inactive at all times for this model.
- If you choose a switch:
- The switch position menu will appear. Scroll to high
light the switch position that you will use to enable
the mix. Press the jog dial to confirm your selection.
- Scroll to select “ON” and press the jog dial to confirm
your selection. If you toggle the selected switch, the
field in the top right corner of the screen will indicate
when the mix is active.
11. Press the back button twice to return to the trainer menu.
To disable the trainer function:
1. Scroll to highlight the “MIX” field in the trainer menu and press
the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the back button to return to the system menu.
Mode
1. To enter the Management menu scroll to MANAGEMENT from
the System Menu and press the jog dial to enter the menu.
2. Scroll to highlight “BACKLIGHT” and press the jog dial to
activate the menu.
3. Scroll to select the amount of time that the screen backlight
will stay active without manipulating the jog dial or back
button. Press the jog dial to confirm your selection
Management Menu
The Management menu allows you to tailor numerous system-wide features of the Flash 7.
From the management menu, you can control the following:
User Interface screen backlight duration and contrast.
Battery type used in the transmitter.
UI Feedback - Audible tones during warnings and when you press or scroll the jog dial.
Warning Setup – Audible warnings when the transmitter is powered on.
3. Scroll through the modes until you find the one you would
like to use. The selected mode will be applied to each
new model that is created. Press the jog dial to confirm your
selection.
Some modes require additional adjustments to the hardware of the Flash 7 transmitter. For more
information on the Flash 7’s hardware adjustments refer to Appendix A. Hardware adjustments.
Warning
Note
Tip
Tip
Tip
Caution
The Flash 7 is capable of operating in control Modes 1 ~ 4. The default is mode 2 for models sold in North
America as this is generally preferred by the majority of pilots.
1. From the system menu, scroll to highlight “MODE” and press
the jog dial to enter the mode selection menu.
2. Press the jog dial again to activate the mode selections.
Summary of Contents for Flash7
Page 1: ......