HITEC Flash7, Instruction Manual, Page: 23 / 52

7 Channel 2.4 GHz Aircraft Computer Radio System 7 Channel 2.4 GHz Aircraft Computer Radio System
Section 3: System Menu Programming Section 3: System Menu Programming
42 43
4. Scroll to highlight “CONTRAST” and press the jog dial to
activate the menu.
5. Scroll to adjust the contrast level of the display screen. Press
the jog dial to confirm your selection.
Management Menu cont.
6. Scroll to highlight “BATTERY” and press the jog dial to activate
the menu.
7. Scroll to select the battery type used in the transmitter. Press
the jog dial to confirm your selection.
The operating voltages of Alkaline and NiCd/NiMh batteries are below the safe discharge
voltages for LiFe and LiPo battery types. Selecting a LiFe or LiPo battery type in the menu when
the actual battery is Alkaline or NiCd/NiMh will cause the Flash 7 to shut down due to low-
voltage settings.
Warning
Note
Tip Tip
Tip Caution
8. Scroll to highlight “UI FEEDBACK” and press the jog dial to
activate the menu.
9. Scroll to select “ON” or “OFF”. When user interface feedback
is turned on, the radio emits a beep each time the jog dial is
scrolled or pressed. The transmitter will emit continuous
beeps if a warning is active. Press the jog dial to confirm your
selection.
10. Scroll to highlight “WARNING SETUP” and press the jog dial
to activate the menu.
11. Scroll to highlight “RF CHECK” and press the jog dial to
activate the menu.
12. Scroll to select “ON” or “OFF”. When RF check is turned on, the
radio will prompt you to approve signal transmission each
time the unit is powered on. Otherwise, the radio will
automatically begin transmitting when powered on. Press
the jog dial to confirm your selection.
13. Scroll to highlight “HIGH THROTTLE” and press the jog dial to
activate the menu.
14. Scroll to select “ON” or “OFF”. When high throttle is turned on,
the radio will warn you if the throttle stick is not at idle when
the unit is powered on. Press the jog dial to confirm your
selection.
15. Scroll to highlight “FLIGHT CONDITION” and press the jog dial
to activate the menu.
16. Scroll to select “ON” or “OFF”. When the flight condition
warning is turned on, the radio will warn you if any
programmed flight conditions are active when the unit is
powered on. Press the jog dial to confirm your selection.
17. Press the back button twice to return to the system menu.
Management Menu cont.
INFO
The Info screen displays the current firmware information for the
radio.
1. From the system menu, highlight “INFO” and press the jog dial
once to see the information.
2. Press the back button to return to the system menu.