7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
Section 5: Acro and Glider Programming Menu
70
71
Camber Mix (GLID Only)
10. Scroll to highlight the “FLAP” field and press the jog dial to
activate the menu.
11. Rotate the jog dial to input the desired travel for the “FLAP”
servo when camber is active. Press the jog dial to conform
your input.
12. If the model has a second flap servo, repeat step 11 in the
“FLP2” field.
15. Scroll to the “S/W” field and press the jog dial twice to
activate the menu.
13. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
14. Scroll to define the amount of time (0.0 to 10.0 seconds) for
the camber settings to fully deploy. Press the jog dial to
confirm your selection.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight
the switch position that you will use to enable the mix.
Press the jog dial to confirm your selection.
16. Scroll to select a switch to activate the camber mix. Press the jog dial to confirm your selection.
a. If you choose the “NULL” option, the mix will remain inactive at all times for this model.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate when the mix
is active.
c. If you choose “Cond” (Flight Condition):
- The upper right field of the menu displays which flight
condition is currently active and will be programmed.
- Scroll to the Flight Condition field and press the jog dial to
activate the menu.
- Choose the desired flight condition and press the jog dial
to confirm your selection.
Camber Mix (GLID Only) cont.
- Repeat steps 4-18 to define the settings for each flight condition.
17. Press the back button to return to the model function menu.
To configure flap control:
1. From the model menu, rotate the jog dial to highlight “FLAP
CON” and press the jog dial once to enter the activation menu.
You may also select a flight condition in this menu by activating the desired flight condition.
Warning
Note
Tip
Tip
Tip
Caution
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to confirm your selection and activate the flap control
menu.
4. Highlight the “FLAP” row of the value table and press the jog
dial to activate the menu.
To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” field in the camber mix menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the back button to return to the model function menu.
Flap Con
Flap Control is used to mix elevator control with flap movements. This is an effective way of avoiding pitch
changes to the aircraft when flaps are deployed.
5. Scroll to highlight the “L/U” (left/up) field and press the jog
dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the assigned flap channel. This value defines the
end point when the flap is fully retracted. Set this value
carefully to avoid any binding of the control linkages. Press the
jog dial to confirm your input.
Summary of Contents for Flash7
Page 1: ......