Hitachi UX2 Series, Instruction Manual

Page: 115 / 300

Chapter 5 Creation and Setting of Print Messages
5-33
Ch
a
pt
e
r 5
.
(13) [
Speed compensation
]
●
Set to prevent changes in the print position.
●
Cannot be set when a [Product speed matching] feature is not specified.
●
Adjusts print start delay according to the set value of "Distance between print head and work".
●
Cannot be used when [Repeat print] is specified.
●
Note that a [Print Overlap Fault] may be generated when the printing interval is extremely short when
the [Speed compensation] setting is changed from "Disable" to "Enable".
●
Fine adjusts the print start delay from the setting value of the [Speed compensation fine control].
However, the following condition must be satisfied.
0
≦
[Print start delay] + [Speed compensation fine control]
(14) [Distance between print head and work]
●
Inputs the distance between the print head and the print target.
●
When [Product speed matching] is "encoder" and "Speed compensation" was set to "Enable", the
print start delay is adjusted by considering the distance between the print head and the print target.
When "Speed compensation" is set to "Disable", the distance between the print head and the print
target is not referenced, even if set.