38
ED-X10/ED-X12(CC9XM2)
Wiring diagram 8
E2
C
N
SH2
TSW
CN
RM
A83
E1
E3
A83
P6
01
P601
TSW
E801
E
301
E80
1
CNBAT
Lamp sirocco
Wiring when attaching the main board (2/2)
Wiring when attaching the main board
(1)Connect the LCD panel flexible cables.
(2)Connect the E2 and exhaust fan.
(3)Connect the speaker
.
(4)Connect and style the E1 and sirocco fan.
(5)Attach the remote control board and connect
and style the CNRM.
(6)Connect and style the E3 and lamp sirocco fan.
Connect the
A83 (speaker) to the main board.
Connect the sirocco fan and E1 to the main
board.
Connect the CNRM to the main board from
above the
A83 (speaker).
Sirocco
fan
Upper case
Main board
Hooked with the CNRM wire.
Attach the upper case
A83
speaker
[CAUTION]
Prevent the wires from protruding to
the outside so that its wires connected
to the connector on the edge of the
main board, such as
A83, are not
pinched and damaged into the casing
when attaching the upper case.
Connect the E2 to the main board
after passing it through the clamp
of the power supply bracket.
Secure by sliding in the direction of the arrow
[CAUTION]
Be careful when handling the LCD panel flexible cable.
FPC connector
LCD panel
Clamp
Exhaust
fan
Connect the exhaust
fan to the main board
after passing it through
the power supply clamp
and TSW.
[CAUTION]
Make sure that wires do
not pass through the
shaded area on the
diagram below, as they
will be pinched by the
ribs of the upper case.
Exhaust
fan