44
ED-X10/ED-X12(CC9XM2)
c. Attach the Lamp door.
2. Replacing the power units.
Remove the 4 screws to take off the ballast bracket.
NOTE
: One of screws is behind the Front Shade.
Remove the
Front Shade
Lamp door
Power supply bracket
CAUTION
The ballast bracket holding the bal-
last power unit is installed under-
neath the power supply bracket.
Be careful not to injure your fin-
gers or hand by the edges of the
ballast bracket during mainte-
nance around the power units.
CAUTION
When re-assembling,
tighten this screw at the
torque of 0.49±0.1N·m so
that the bottom case
does not strain.
Ballast bracket
CAUTION
Tighten this screw using a manual screwdriver.
Push
PCB holder
PCB holder
Push
UP
UP
keep
NOTE
: Detaching power
unit(circuit)