Hirschmann BAT 11b, Management Manual, Page: 29 / 128

Connection to the Ethernet
29
BAT 11b
Release 1.0 03/04
1. Screw the standard antenna onto the connector
designed for this purpose. Adjust the antenna to the
desired position.
2. If you wish to use an antenna with a TNC plug of the
Hirschmann product portfolio, use the adapter from the
RSMA plug to the TNC jack (optionally available) as
adapter.
Connection to the Ethernet
1. Insert one end of the RJ45 patch cable into the port 1 or
port 2 of the BAT 11b. Do only use an Ethernet port to
connect or configure the device.
Note:
Standard patch cables 1:1 or cross-over cables (RJ45-
RJ45) are designed symmetrically. It is therefore not
possible to confuse the cable ends.
If you use the BAT 11b Wireless Ethernet as an access
point at a switch, you require a 1:1 patch cable. If you
want to connect it as a client to a computer with Ether-
net interface or if you wish to cascade two BAT 11b Wire-
less Ethernets with each other, you need a cross-over
cable.
2. Insert the other end into a free Ethernet port.
Connection to the Power Supply
1. When the supply voltage is connected via the 2-pin ter-
minal, start up the BAT 11b.
2. Lock the terminal block with the side locking screws.
3. The middle status LED indicates whether the BAT 11b is
properly connected to the power supply.