Hioki BT3564, Instruction Manual, Page: 156 / 210

8.6 Message Reference
150
Execute a Measurement and Read the Measured Values
Syntax Query :READ?
Response <Measured resistance (NR3)>, <Measured voltage (NR3)>
(

V mode)
<Measured resistance (NR3)> (

mode)
<Measured voltage (NR3)> (V mode)
Description Query Switches from the Idle State to the Trigger Wait State, then reads the
next measured value. With auto-ranging enabled, the most suitable
range is selected before measurement.
Example
Query :READ?
Response 289.68E-3, 1.3921E+0
(

V mode)
Measured resistance is 289.68 m

, and voltage is 1.3921 V.
Error This command causes an execution error if issued during the Continuous Mea-
surement state (after
:INITIATE:CONTINUOUS ON
).
Note • The next command does not execute until measurement is finished.
• When the trigger source is external, the

TRG
command does not trigger mea-
surement.
• Wait 100 ms before applying the trigger with
:READ?
immediately after
changing the measuring conditions during measurement.
See " Measurement Value Formats" (

p.151).
Trigger Source Operation
IMMediate
Triggers and reads measured value.
EXTernal
After triggering by the TRIG terminal (EXT I/O) or
TRIG
key,
reads the measured value.
HIOKI BT3564A961-02