Hioki BT3564, Instruction Manual, Page: 149 / 210

8.6 Message Reference
143
8
Chapt
er 8
RS-232
C
/GP-I
B
In
te
rf
aces
EOM Signal Output Method Settings (software version 1.15 or later)
The following 2 methods can be selected as the EOM signal output method for external I/O. (The EOM sig-
nal is set to on at end-of-measurement and set to off according to the output method that has been set)
• HOLD
Holds the EOM signal until mesurement starts by the next trigger signal.
• PULSE Sets EOM=OFF according to the specified pulse width.
Also, the pulse width can be set between 0.001 to 0.099 seconds when PULSE is selected.
EOM Output Mode Setting
Syntax
Command
Query
Response
:
SYSTem:EOM:MODE
<HOLD/PULSE>
: SYSTem:EOM:MODE?
<HOLD/PULSE>
HOLD..........Holds the EOM signal until mesurement starts by the
next trigger signal.
PULSE .......Sets EOM=off according to the specified pulse width.
Example Command :SYST:EOM:MODE PULS
EOM Pulse Width Setting
Syntax
Command
Query
Response
: SYSTem:EOM:PULSe
<Pulse width>
: SYSTem:EOM:PULSe?
<Pulse width> = 0.001 to 0.099 (NR2)[second]
Example Command
:SYST:EOM:PULS 0.005
System Reset
Syntax
Command :SYSTem:RESet
Description Command All settings including saved panel settings are returned to factory
defaults. Refer to “Reset Function” for details.
Example Command
:SYST:RES
Note
• If you want to preserve saved data, use the
 RST
command instead.
• The communication conditions are not initialized.
HIOKI BT3564A961-02