22
Instructions for fitting
DS-WS repair sleeves
(Item no. 235841)
Fitting a repair sleeve (first
end)
Important: The service life of
the connectors is several
times that of the repair sleeve.
Clamp the diamond wire
in the vice and use an
angle grinder to cut off
the end 13 mm from the
first bead.
Use pliers to remove the
spring (pull out).
Remove the rubber neatly
over a length of 10 mm
(using a knife, cigarette
lighter or wire brush).
Fit an O-ring
쩸
(Item no.
235844) pushing it onto
the wire until seated
against the bead. Fit a
repair sleeve
쩺
onto the
wire so that the end of the
bare wire section contacts
the base of the hole.
Use the crimping pliers
쩺
(Item no. 235845) and
the corresponding
crimping jaws to crimp
the connector fully in oneoperation. When doing so, the crimping jaws should be positioned 1 mm from
the end of the connector. Worn or deformed crimping jaws should not be used.
Fitting a repair sleeve
(second end)
■
Proceed as described at steps
to
.
■
Twist the diamond wire, approx. 1–1.5 turns per metre length of wire, in a counterclockwise direction (to the
left) as seen when looking straight at the cut face of the end of the wire.
■
Proceed as described at steps
to
.
E
D
C
A
E
D
C
B
A
13 mm
A
10 mm
B
10 mm
C
y
v
D
c
E
9. Instructions for connecting Hilti DS-W 10.5 diamond wire
Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01
