![background image](http://html1.mh-extra.com/html/hilti/ds-wss-30/ds-wss-30_operating-instructions-manual_2136342027.webp)
27
CAUTION
Disconnect the supply cord plug from the power outlet.
CAUTION
Keep the machine, especially its grip surfaces, clean and free from oil and grease. Do not use cleaning agents
which contain silicone.
11.1 Cleaning using high-pressure or steam-cleaning systems
Avoid directing the jet towards the bearings and seals when systems of this kind are used for cleaning the guide
pulley stands and saw head.
11.2 Maintenance of the single-pair pulley stand
As the guide pulleys used for flush cutting are
equipped with two ball bearings at the pivot, these
should be lubricated at least once a month.
Procedure: Unscrew the locking bolt completely and
inject a little oil into the threaded opening. Reinsert
the bolt (see fig. 11.2).
11.3 Rubber rim on the pulleys
The rubber rim on the drive wheel and guide / return pulleys should be checked at regular intervals. A wheel or
pulley should be replaced as soon as the aluminium beneath the rubber is visible (rubber worn through).
11.4 Diamond wire guard and drive wheel guard
These parts should be cleaned daily and checked to ensure that the rolling-up mechanism of the diamond wire
guard always functions correctly.
11.5 Maintenance of the hydraulic power unit, saw head and other saw modules
Please refer to the D-LP 32 (30) / DS-TS 32 (30) operating instructions.
11.2
Locking bolt
11. Care and maintenance
Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01