![background image](http://html1.mh-extra.com/html/hilti/ds-wss-30/ds-wss-30_operating-instructions-manual_2136342021.webp)
21
10 mm
10 mm
13 mm
1
y
x
2
4
c
5
3
1 mm
Instructions for fitting
DS-WC connectors
(Item no. 340427)
Fitting the connector (first
end, clevis piece)
Clamp the diamond wire
in the vice with the cut-
ting direction as shown
(see arrow) and use an
angle grinder to cut off
the end 13 mm from the
first bead.
Use pliers to remove the
spring (pull out).
Remove the rubber neatly
over a length of 10 mm
(using a knife, cigarette
lighter or wire brush).
Fit an O-ring
쩸
(Item no.
235844) pushing it onto
the wire until seated
against the bead. Fit the
clevis piece
쩹
onto the
wire so that the end of the
bare wire section contacts
the base of the hole.
Use the crimping pliers
쩺
(Item no. 235845) and
the corresponding crimp-
ing jaws to crimp the
connector fully in one
operation. When doing so, the crimping jaws should be positioned 1 mm from the end of the connector.
Worn or deformed crimping jaws should not be used.
Fitting the connector (second end, opposite piece) and joining the connectors
■
To fit and crimp the second part of the connector (opposite piece) proceed as described at steps
to
.
■
Joining the connectors
Twist the diamond wire, approx. 1–1.5 turns per metre length of wire, in a counterclockwise direction (to
the left) as seen when looking straight at the cut face of the end of the wire. Bring the connectors together
and insert the pin (item no. 235842) using a hammer to drive it in flush.
Opening the connectors
■
Use a punch to drive the pin out of the connector. Replace the pin if it is badly worn (replacement pin, item
no. 235842).
9. Instructions for connecting Hilti DS-W 10.5 diamond wire
Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01