![background image](http://html.mh-extra.com/html/hilti/ds-ts-5-se/ds-ts-5-se_operating-instructions-manual_2136336030.webp)
30
Operation
speed of advance is automatically reduced or increased
depending on the resistance met by the diamond saw
blade. This ensures that the DS TS 5-SE automatically
makes use of the maximum power available when opera-
ting under full load.
Ending the sawing procedure
– The saw blade should always be lifted out of the cut
while still rotating when, for example, the sawing pro-
cedure in interrupted in order to change a blade or
when the concrete has been cut through and the saw-
ing operation is complete.
– As soon as the saw blade has been fully lifted out of
the cut, proceed as follows:
1. Switch off the saw blade drive.
2. Turn off the water.
3. Bring the saw arm into its highest position (at 90°
to the rail) and advance the saw head to the desired
position.
4. All controls on the remote control unit should be
returned to the
0
or
neutral
position. If further cuts
are to be made and the saw head is simply being
repositioned without disconnecting the mains plug,
the main switch on the saw head does not have to
be turned to the
0
position. Press the emergency
OFF button as a safety precaution.
4.8
5. Dismantling the saw system
– Advance the saw head
쐃
to the desired position and
bring the saw arm to its highest point (at 90° to the
rail) ready for fitting the saw blade the next time. Switch
off the power by turning the main switch on the saw
head to
씏
0
(switch returns to the middle position
when released).
– Before disassembly of the wall saw can begin, the
sawn-out concrete blocks must be secured to prevent
them from falling. Use the steel wedges provided in
the tool box.
– Disconnect the saw head power cable from the mains
supply.
– Clean the electric wall saw by spraying it with water
and drying with a cloth.
– Remove the saw blade guard.
– Remove the saw blade.
– Disconnect the remote control cable from the saw head.
– Pull up the release lever
��� ���
and remove the saw
head from the carriage.
– The carriage
쐄
may be left on the rail or removed, as
desired.
– Release and remove the rail.
– Release and remove the rail supports.
– Moving parts of the saw head locking mechanism
���
and the rail supports
���
should be lubricated with oil
spray before being put away.
– Store the electric wall saw in the trolley box (optional
accessory, depending on version).
Caution: Be prepared to take the weight of
the saw head when releasing it from the car-
riage. Keep one hand on the carrying grip!
5
6
1
2
4
3