ø 700/745 mm = max. 1000 rpm
ø 700/745 mm
ø 500 mm
쐃
쐇
쐋
25
Operation
Cutting speed and saw blade speed (rpm)
The optimum cutting speed (blade peripheral speed)
depends on a number of factors such as:
concrete quality, aggregates and steel reinforcement
content.
3.2
The DS TS 5-SE electric wall saw can be operated with-
in the 800 to 1200 rpm speed range. The speed can be
adjusted, with infinite control, to the optimum setting
within this range and is always indicated in the display
(bright spot).
Caution:
The saw must not be operated (sawing) at a
speed below 800 rpm.
Operation of the saw at speeds greater than 1000 r.p.m.
with blades of 700 / 745 mm in diameter is not permis-
sible.
Guide values for the DS TS 5-SE electric wall saw
Saw blade dia.
Speed
Cutting speed
(mm)
(rpm)
(m/sec.)
500
1200
31
700
850–1000
31–37
745
800–1000
31–39
Basic rules concerning blade peripheral speed
or cutting speed
– The blade peripheral speed or, respectively, the spin-
dle speed (rpm) should be reduced when the concrete
contains hard aggregates (types of rock such as silex
and flint)
– A higher blade peripheral speed or, respectively, a slight-
ly higher spindle speed (rpm) can be selected when
the concrete cuts easily.
– The blade peripheral speed or, respectively, the spin-
dle speed (rpm) should be reduced when a high steel
reinforcement content is encountered.
3.3
쐃
Saw blade speed (rpm) indicator
���
Recommended speed range
���
Saw blade drive speed
regulator