23
Operation
1
5
3
4
6
2
7
4
3
1
2
DS
TS
5-SE
Flush cutting
For flush cutting, the saw blade is mounted directly on
the saw blade drive flange using 3 countersunk-head
screws. The standard saw blade flange and central fas-
tening screw are not used. The anchor placement dimen-
sions and the check dimension thus remain exactly the
same as for standard cutting. The three plastic plugs
must be unscrewed before mounting the saw blade. At
the same time, to prevent dirt entering the threaded hole
during flush cutting, an M12 plastic plug must be insert-
ed in the central M12 bore. To prevent dirt entering the
threaded holes, the plastic plugs should be reinserted
after completion of flush cutting.
No.
Designation
쐃
Saw arm
���
Saw blade
���
Saw blade fastening screws
���
6 mm internal hex. wrench with T-grip
���
Saw blade mounting flange
���
Plastic plugs M10 (3 piece)
쐆
Plastic plugs M12 (1 piece)
2.15
Connecting the remote control unit, power
and water
No.
Designation
쐃
Connect the bayonet-type plug of the DS-RC-
TS 5-E remote control unit to the socket on the
saw. Connect the cover caps of the plug con-
nections together (prevents the entrance of
dirt).
���
Connect the power cable to the mains supply
via the extension cable. The mains supply must
comply with the specification on the rating
plate.
���
Connect the water supply to the upper connec-
tion (with Gardena coupling).
���
If required, connect the water return hose (with
Gardena coupling) to the lower connection.
2.16