![background image](http://html.mh-extra.com/html/hilti/dd-150-u/dd-150-u_manual_2135214020.webp)
12
English
2204402
*2204402*
Connection interrupted
An existing Bluetooth connected to a device or accessory has been inter-
rupted.
Analysis of running time
The display shows drilling time (diamond core drilling machine actually
drilling) at the top and operating hours (diamond core drilling machine
switched on) at the bottom. Both figures are shown in hours, minutes and
seconds.
To reset drilling time and all other analysis data, press the
button and
hold it down for a few seconds.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Analysis of operating
behavior
This display shows contact pressure during drilling time as a percentage
(%). This enables user behavior to be optimized.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Analysis of drilling direction
This display shows an evaluation of the drilling directions in %.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Analysis of gear selection
This display shows an evaluation of the duration of use of the respective
gear in %. The arrow always points to the gear with the highest rate of use.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Analysis of use
This display shows the use of the diamond core drilling machine in the
hand-guided and in the stand-guided mode in %.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Connected devices
This display provides an overview of all devices and accessories connected
to the diamond core drilling machine.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Start connection setup
Start connection setup process at the diamond core drilling machine first
and then at the device or accessory you want to connect.
To start the process of establishing the connection, simultaneously press
the
and
buttons and hold them down for at least 1 second.
• The information shown on the display disappears automatically after a
few seconds or when you press the
button again.
• Pressing the
again takes you to the next analysis data.
Gear selector not latched
The gear selector is in an intermediate position or is not correctly latched.
Operate the gear selector until it latches completely.
Summary of Contents for DD 150?U
