Hilberling PT-8000A, Operating Manual

Page: 87 / 122

PT-8000A Appendix A1 v2.00.33 A1-
7
In the IF-Monitor window open the menu
Tools
and click the entry
Screen (Fig.
A1-
15).

The window Screen will be opened
(Fig.
A1-
16).
This window offers to you three options of settings to adjust the display of the
signal level.
Proceed as follows:
1.
Use slider Scale move to shift dBm scale vertically, so that Automarkers
displayed Peak value is close to the dBm value shown on the PT-8000A
display.
(Range ±50 dBm in 10 dBm steps, default value is 0)
2.
Use up and down arrows or input value directly to shift the curve up and
down, so that Automarkers displayed Peak value is equal to value shown
on the PT-8000A display.
(Range ±20 dBm in 1 dBm steps, default value is 0)
3.
If the curve exceeds the display range, both dBm scale and curve jointly
can be moved vertically by using up and down arrows or direct value
input.
(Range ±40 dBm in 1 dBm steps, default value is 0)
This parameter allows to control the smoothing of curve. The number of
measured points which are the source of an average value can be modified by
using up and down arrows or direct value input.
(Range 0 ... 20 increment 1, default value is 3)
Click OK to terminate the adjustment.
Made changes are stored and will be used when program has been started
the next time.
Fig.
A1-
16
Scale move
Measured value to adjust
Move screen
Average over
Fig.
A1-
15