Hilberling PT-8000A, Operating Manual

Page: 44 / 122

36
MEM menu
11.3.2 Storage of Frequencies MEM
Pushing MEM button located in the cluster MODE will store the frequency and
additional VFO values of the active RX to one of the 297 memory channels
organized in three banks with 99 memory channels each bank.
Other than CHANNEL operation (see Page 34) the RX will stay on its current
VFO adjustments while MEM functions are executed.
When pushing MEM:

MEM LED will be on.
 MEM menu will be called up (see below).

The frequency display of the standby VFO will be substituted by
information about the selected memory channel (see Page 37 Figure 45).
When MEM function is activated toggling between MAIN- and SUB-RX is
inhibited; same with toggling VFO-A and B.
Select bank #1; the softkey will be displayed inverse.
Select bank #2; the softkey will be displayed inverse.
Select bank #3; the softkey will be displayed inverse (as shown here).
Writing current VFO adjustments to selected memory channel; if this channel
was selected for SCAN-modus the earmark will be deleted; it must be selected
again if required (see also Page 34 – CHANNEL).
Pushing softkey BANK 1, BANK 2 and BANK 3 gives access to the banks. Use
MEM/CH / STEP-VFO to select desired memory channel (0 … 99).
Set
SCAN
Fig. 43
Fig. 44