HikRobot ID5000 Series, User Manual

Page: 39 / 107

ID5000 Series Smart Code Reader User Manual
30
8.1.5 Set Light Source
You can select different light types, and set their related parameters in the light interface.
Note
● Light source parameters may differ by device models.
● Make sure you have selected the device to be set in Device Connection before setting light
source parameters.
You can select different light sources in Light Type .
Own Lighting
It refers to use the device's embedded light source to light during code reading.
External Lighting
It refers to the device controls the external light source by triggering output signal during code
reading.
Non-Lighting
It refers to the device turns off light source during code reading.
Note
If you select Non-Lighting as Light Type , you do not need to set any parameters.
Set Own Lighting
If you select Own Lighting as Light Type , you can set the following parameters.
Aiming Light Enable
You can enable Aiming Light Enable to enable the device’s aiming light.
Note
The parameter of aiming light enable may differ by device model.
Lighting Selector
You can click lamps on the light source illustration to turn on or turn off lamps on different
directions.
Note
The specific lighting selector may differ by device model. For devices with 4 groups of lamps, you
can check
All to turn on all lamps. For devices with 6 groups of lamps, you can click All On or All
Off to turn on or turn off all lamps.
Light Mode
It has 2 light modes, including Flash Strobe and Flash Long . Flash Strobe means the light flashes