16
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
1. Power
tool
Symptom
Possible cause
Remedy
Tool doesn’t run
No remaining battery power
Charge the battery.
Battery isn’t fully installed.
Push in the battery until a click is heard.
Concrete dust is accumulated on the
terminals of the battery installation
compartment as well as on the battery
sliding grooves.
Clean o
ff
the accumulated concrete dust
with a dry cloth.
Suction power is weak.
Fails to suck in dust.
The tank is full of dust or water.
Dispose of the dust or water.
After that, remove any dust attached to
the
fi
lter.
Filter is clogged.
Conduct air blow dusting or remove the
dust attached to the
fi
lter.
The
fi
lter is not installed.
(Not set in place)
Check to see if the
fi
lter is properly set.
Plastic bag is incorrectly installed.
Properly install the plastic bag.
Dust leaks from the vent.
Filter is not installed.
Filter is improperly installed.
Properly install the
fi
lter.
Filter is damaged.
Replace the damaged
fi
lter.
Tool suddenly stopped
Tool was overburdened
Get rid of the problem causing the
overburden.
The battery and/or the unit is overheated.
Let the battery and/or the unit cool down.
Attachments such as the
connection adapter or joint
-can’t be attached
-fall o
ff
The shape or the dimensions of an
attachment part does not match.
Check the model in use and make sure
to use the designated accessories and
attachments listed in this document or in
our catalogue.
Battery cannot be installed Attempting to install a battery other than
that speci
fi
ed for the tool.
Please install a multi volt type battery.
000Book̲RP3608DA̲EU.indb 16
000Book̲RP3608DA̲EU.indb 16
2019/07/24 14:00:55
2019/07/24 14:00:55
