English
53
14. Compound cutting procedures
Compound cutting can be performed by following the instructions in 12 and 13 above. For
maximum dimensions for compound cutting, refer to “SPECIFICATIONS” table.
CAUTION
Always secure the workpiece with the right or left hand and cut it by sliding the
round portion of the saw backwards with the left hand.
It is very dangerous to rotate the turntable to the left during compound cutting
because the saw blade may come into contact with the hand that is securing the
workpiece.
In case of compound cutting (angle + bevel) by left bevel, slide the sub-fence (B)
outward, and engage in the cutting operation.
In case of compound cutting (angle + bevel) by right bevel, remove the sub-fence
(A), and engage in the cutting operation.
15. Cutting long materials
When cutting long materials, use an auxiliary platform which is the same height as the
holder (optional accessory) and base of the special auxiliary equipment.
Capacity: wooden material (W × H × L)
300 mm × 45 mm × 1300 mm, or
180 mm × 25 mm × 2000 mm
16. Installing the holders ... (Optional
accessory)
The holders help keep longer
workpieces stable and in place
during the cutting operation.
(1) As indicated in
Fig. 25
, use a
steel square for aligning the upper
edge of the holders with the base
surface.
Loosen the 6 mm wing nut. Turn a
height adjustment bolt 6 mm, and
adjust the height of the holder.
(2) After
adjustment,
fi
rmly tighten
the 6 mm wing nut and fasten the
holder with the 6 mm knob bolt
(optional accessory). If the length of Height Adjustment Bolt 6 mm is insu
ffi
cient, spread a
thin plate beneath. Make sure the end of Height Adjustment Bolt 6 mm does not protrude
from the holder.
CAUTION
○
When transporting or carrying the tool, do not grasp the holder.
○
There is the danger of the holder slipping out of the base. Grasp the handle
instead of the holder.
Holder (Optional accessory)
6 mm Knob Bolt
(Optional accessory)
Base Surface
Fig. 25
Steel Square
6 mm Wing Nut
(Optional accessory)
Height Adjustment
Bolt 6 mm
(Optional accessory)
000Book̲C12RSH2̲ChS.indb 53
000Book̲C12RSH2̲ChS.indb 53
2018/03/27 15:00:47
2018/03/27 15:00:47
