English
43
When changing the bevel angle to the right 45°, pull the set pin (A) on the direction shown
in
Fig. 7-b
and incline the motor head to the right.
When adjusting the motor head to 0°, always return the set pin (A) to its initial position as
shown in
Fig. 7-b
.
Fig. 7-a
8 mm Set Screw
(Stopper for 0°)
Indicator
(For right bevel scale)
8 mm Bolt (B)
(Stopper for right 45°
bevel angle)
Fig. 7-b
Set pin (A)
Indicator (For left bevel scale)
8 mm Bolt (A)
(Stopper for left 45° bevel angle)
11. Checking the saw blade lower limit position
Check that the saw blade can be lowered
9 mm to 10 mm below the table insert.
When you replace a saw blade with a new
one, adjust the lower limit position so that
the saw blade will not cut the turntable or
complete cutting cannot be done.
To adjust the lower limit position of the saw
blade, follow the procedure (1) indicated
below. (
Fig. 8
)
Furthermore, when changing the position of a 8 mm depth adjustment bolt that serves as a
lower limit position stopper of the saw blade.
(1) Turn the 8 mm depth adjustment bolt, change the height where the bolt head and the hinge
contacts, and adjust the lower limit position of the saw blade.
NOTE
Con
fi
rm that the saw blade is adjusted so that it will not cut into the turntable.
Gear Case
8 mm Depth
Adjustment
Bolt
Hinge
Fig. 8
000Book̲C12RSH2̲ChS.indb 43
000Book̲C12RSH2̲ChS.indb 43
2018/03/27 15:00:42
2018/03/27 15:00:42
