English
48
WARNING
○
Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned o
ff
.
○
Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
○
Do not remove the laser marker to be used for other purposes.
CAUTION
(
Fig. 16
)
○
Laser radiation - Do not stare into
beam.
○
Laser radiation on work table. Do
not stare into beam. If your eye is
exposed directly to the laser beam,
it can be hurt.
○
Do not dismantle it.
○
Do not give strong impact to the
laser marker (main body of tool);
otherwise, the position of a laser
line can go out of order, resulting in the damage of the laser marker as well as a
shortened service life.
○
Keep the laser marker lit only during a cutting operation. Prolonged lighting of the
laser marker can result in a shortened service life.
○
Use of controls or adjustments or performance of procedures other than those
speci
fi
ed herein may result in hazardous radiation exposure.
NOTE
○
Perform cutting by overlapping the ink line with the laser line.
○
When the ink line and the laser line are overlapped, the strength and weakness of light
will change, resulting in a stable cutting operation because you can easily discern the
conformity of lines. This ensures the minimum cutting errors.
○
In outdoor or near-the-window operations, it may become di
ffi
cult to observe the laser line
due to the sunlight. Under such circumstances, move to a place that is not directly under
the sunlight and engage in the operation.
○
Check and make sure on a periodic basis if the
position of the laser line is in order. As regards the
checking method, draw a right-angle ink line on
the workpiece with the height of about 20 mm and
the width of 150 mm, and check that the laser line
is in line with the ink line [The deviation between
the ink line and the laser line should be less than
the ink line width (0.5 mm)]. (
Fig. 17
)
Fig. 16
Laser line
Fig. 17
Marking (pre-marked)
000Book̲C12RSH2̲ChS.indb 48
000Book̲C12RSH2̲ChS.indb 48
2018/03/27 15:00:45
2018/03/27 15:00:45
