English
45
2. Using the Vise Assembly (Standard
accessory) (
Fig. 11
)
(1) The vise assembly can be mounted on
either the left fence {Fence (B)} or the
right fence {Fence (A)}.
(2) The screw holder can be raised or
lowered according to the height of the
workpiece.
(3) Turn the upper knob and securely
fi
x the
workpiece in position.
WARNING
Always
fi
rmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
CAUTION
Always
con
fi
rm that the motor head does not contact the vise assembly when
it is lowered for cutting. If there is any danger that it may do so, move the vise
assembly to a position where it will not contact the saw blade.
3. Positioning the table insert (
Fig. 12
)
Table inserts are installed on the turntable. When shipping the tool from the factory, the
table inserts are so
fi
xed that the saw blade does not contact them. The burr of the bottom
surface of the workpiece is remarkably reduced, if the table insert is
fi
xed so that the gap
between the side surface of the table insert and the saw blade will be minimum. Before
using the tool, eliminate this gap in accordance with the following procedure.
Table
Insert
Turntable
Table Insert
Table Insert
Saw Blade
6 mm
Machine
screw
6 mm Machine
screw
Fig. 12
Right angle cutting
Left bevel angle cutting
Right bevel angle cutting
Saw Blade
Saw Blade 6 mm
Machine
screw
(1) Right angle cutting
Loosen the three 5 mm machine screws, then secure the left side table insert and
temporarily tighten the 5 mm machine screws of both ends. Then
fi
x a workpiece (about
200 mm wide) with the vise assembly and cut it o
ff
. After aligning the cutting surface with
the edge of the table insert, securely tighten the 5 mm machine screws of both ends.
Remove the workpiece and securely tighten the 5 mm center machine screw. Adjust the
right hand table insert in the same way.
(2) Left and right bevel angle cutting
Adjust the table insert in the manner same procedure for right angle cutting.
Screw Holder
Hex. socket set
screw (Optional
accessory)
Vise Shaft
Sub Fence (A)
(Sub Fence (B))
Knob
Vise Plate
Fence (A)
(Fence (B))
Workpiece
Fig. 11
000Book̲C12RSH2̲ChS.indb 45
000Book̲C12RSH2̲ChS.indb 45
2018/03/27 15:00:43
2018/03/27 15:00:43
