English
54
17. Stopper for precision
cutting (Stopper and
holder are optional
accessory)
The stopper facilitates
continuous precision
cutting in lengths of 285
mm to 450 mm.
To install the stopper,
attach it to the holder with
the 6 mm knob bolt as
shown in
Fig. 26
.
18. Con
fi
rmation for use
Crown molding vise,
Crown molding Stopper (L) and (R) (Optional accessory)
(1) Crown molding Stopper (L) and (R) (optional accessories) allow easier cuts of crown
molding without tilting the saw blade. Install them in the base both-sides side to be
shown in
Fig. 27
. After inserting tighten the 6mm knob bolts to secure the Crown molding
Stoppers.
(2) The crown molding vise (B) (Optional accessory) can be mounted on either the left fence
(Fence (B)) or the right fence (Fence (A)). It can unite with the slope of the crown molding
and vice can be pressed down.
6 mm Knob Bolt
(Optional accessory)
Crown molding Stopper (L)
(Optional accessory)
6 mm Wing Nut (Optional accessory)
6 mm Knob Bolt
(Optional accessory)
Fig. 27
Crown molding Vise Ass’y
(Optional accessory)
Crown molding Stopper (R)
(Optional accessory)
Then turn the upper knob, as necessary, to securely attach the crown molding in position.
To raise or lower the vise assembly,
fi
rst loosen the hex. socket set screw.
After adjusting the height,
fi
rmly tighten the 6 mm wing bolt; then turn the upper knob, as
necessary, to securely attach the crown molding in position (
Fig. 28
).
Stopper
(Optional accessory)
Workpiece
6 mm Knob Bolt
(Optional accessory)
Holder
(Optional accessory)
6 mm Wing Nut
(Optional accessory)
Height Adjustment Bolt 6 mm
(Optional accessory)
Fig. 26
000Book̲C12RSH2̲ChS.indb 54
000Book̲C12RSH2̲ChS.indb 54
2018/03/27 15:00:48
2018/03/27 15:00:48
