English
44
PRIOR TO CUTTING
1. Cutting a groove on the guard
Holder (A) has a guard (see
Fig. 9
) into which a groove must
be cut when using the tool for the
fi
rst time. Loosen the 6 mm knob
bolt to retract the guard slightly.
After placing a suitable wooden
piece to sit on the fence and the
table surfaces,
fi
x it with the vise.
Slide the motor head backwards
to the end. Then tighten the
slide securing knob. After the switch has been turned on and the saw blade has reached
maximum speed, slowly lower the handle to cut a groove on the guard. (see
Fig. 19 on
page 50
)
CAUTION
Do not cut the groove too quickly; otherwise the guard might become damaged.
Do not use slide cutting for grooving tasks.
PRACTICAL APPLICATIONS
WARNING
○
To avoid personal injury, never remove or place a workpiece on the table while the
tool is being operated.
○
Never place your limbs inside of the line next to warning sign while the tool is
being operated (see Fig. 10).
This may cause hazardous
conditions.
CAUTION
○
It is dangerous to remove or
install the workpiece while the
saw blade is turning.
○
When sawing, clean o
ff
the
shavings from the turntable.
○
If the shavings accumulate too much, the saw blade from the cutting material will
be exposed. Never subject your hand or anything else to go near the exposed
blade.
1. Switch
operation
Pulling the trigger turns the switch on. Releasing the trigger turns the switch o
ff
.
Handle
Saw Blade
Vise Assembly
Fence (B)
Workpiece
Holder (A)
6 mm Knob Bolt
Guard
Fence (A)
Fig. 9
Warning sign
Warning
sign
Line
Line
Fig. 10
000Book̲C12RSH2̲ChS.indb 44
000Book̲C12RSH2̲ChS.indb 44
2018/03/27 15:00:42
2018/03/27 15:00:42
