HemoCue 201 DM, Reference Manual

Page: 109 / 203

104
4 Patient Test procedure
This chapter guides you through the process of performing a Patient Test.
4.1 Patient Test
The Patient Test procedure may vary, depending on which information requirements have
been activated in the Settings, see section
3.4.2 Patient Test Settings . The following
information may be required:
• Cuvette Batch No.
• Patient ID
• Lab ID
A Patient Test procedure may be initiated in two different ways. The first way is described
below. The other way is by filling and inserting a Cuvette, then closing the Cuvette holder,
allowing required information to be entered while the sample is being analyzed.
08/09/03 10:55 AM
JAMES SMITH
1
2
2
3
FIGURE 4-1
a) In the Main Menu, press the Patient Test
button (1).
b) FIGURE 4-2 will be displayed.
1 Patient Test button
2 If the small hourglass is displayed only these
buttons can be used.
3 Operator name, Operator ID or blank,
depending on the settings