Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
31
Installation of the awning
Screw the clamping piece (1) into the arm bearing (3) from the bottom.
After tightening the two fastening screws (2) the arm bearing (3) is firmly
connected to the bracket (6). The fastening screws must be tightened
reciprocally with 8Nm.
Legend
Clamping piece
Arm bearing
Bracket
Fastening screw DIN
912 M6x20 with
precote 30
View from the bottom
Clamping pin
Allen key A/F 5
The articulated arms are under high mechanical stress. The cover
prevents a discharge of this potential energy.
There is danger to life.
Note!
It is not allowed to extend the awning before the fastening screw (2) has
been tightened. There is a high risk of injury and danger to life!
1
2
3
4
6
5
7
Installation Instructions and Instructions for Use
32
Subject to technical modifications. – Date of Issue
September/2020
Installation of the awning
Finally clip the inspection cover (1) into the statics profile (2) from the
bottom.
In addition, the inspection cover (1) must be secured on both ends by
means of the fastening screw (4).
Legend
Inspection cover
Statics profile bottom
Detail section view
Fastening screw pan-
head tapping screw
3.9x25 AW20
End cap
1
2
3
1
4
5
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
33
Installation of the awning
Installation in recess
Legend
Ordering width
50
50
1
Installation Instructions and Instructions for Use
34
Subject to technical modifications. – Date of Issue
September/2020
Awning installation modular
With the modular delivery of the PAN 7040 awning, this is delivered in two assemblies incl.
mounting material.
Modular separation
Legend
Upper modular group
Lower modular group
Brackets and mounting
material
Swivel the lower modular assembly, as shown, in the bracket so that the
nose of the arm bearing engages in the bracket.
Legend
Wall bracket
Arm bearing
1
2
3
1
2
