Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
47
Adjusting the awning
Inclination adjustment with standard arm bearing
Legend
Wall bracket
Adjusting spindle
Awning casing
Allen key A/F 6
Tilting arm bearing
Support at the front rail
6
2
1
3
4
5
Installation Instructions and Instructions for Use
48
Subject to technical modifications. – Date of Issue
September/2020
Adjusting the awning
Arm adjustment
Ex works your awning is optimally adjusted. To ensure a correct closing of the awning, the
folding arms (1) should be in a parallel position to the front rail (2). The arm bearing bolt is
mounted in an eccentric bush (6). You can adjust the folding arms at any time as follows:
In order to correct the angle, you must open the fastening screw for the
eccentric bush (4) by means of an Allen key 2.5 mm (5) first. In order to
access the threaded pin, you must extend the awning (see illustration on
the next page).
Then retract the awning to approx. 0.5 m and correct the position of the
arm by turning the eccentric bush (6) by means of an Allen key 8 mm (7).
Please note:
The position mark (9) of the eccentric bush must be within
the indicated adjustment range (10). Otherwise the parallelism of the arm
to the casing can be adjusted, however, the awning will still extend askew.
The arm should be parallel to the casing of the awning! For facilitated
adjustment, the arm can be supported by hand (8).
Check the adjustment of the inclination and, if necessary, repeat the
described procedure until the desired result has been reached.
Now the adjusting procedure of the arm bearing (3) regarding the arms is
finished. The adjusting procedure on the right side must be performed
analogously.
Please note:
Finally re-tighten the fastening screws (4)!
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
49
Adjusting the awning
Arm adjustment
Legend
Folding arm
Allen key A/F 8
Front rail
Lifting the folding arm
Tilting arm bearing
Position mark of the eccentric bush
Fastening screw for eccentric bush
Adjustment range (opposite side in
mirror image)
Allen key AF2.5
Casing awning
Eccentric bush for arm adjustment
View from the bottom
min.
max.
6
4
9
3
11
12
6
7
5
4
3
8
1
2
10
11
Installation Instructions and Instructions for Use
50
Subject to technical modifications. – Date of Issue
September/2020
Upper covering profile inspection
The awning allows the removal of the upper covering profile for inspection purposes (such
as cover exchange).
To this end, you must perform the following steps:
Loosen the fixing screws (23) on the inspection cover (1) and remove
them.
Legend
Inspection cover
Fastening screw
End cap
End plate
Remove the end caps (3) that have been clipped on the cassette.
After that, you must remove the three screws (4) on the sides, that hold
the upper covering profile in place. Remove the two front clamps (3) from
the end plate (see the Figure) as well. Extend the awning for approx. 300
mm. to be able to perform the following steps better.
1
2
3
3
4
