Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
15
Overview tensioning bracket types
Legend
Wall bracket type B (Art. no. 03650502)
Wall bracket type D (Art. no. 03650503)
Wall bracket type I (Art. no. 03650505)
Attention!
For the wall bracket type B and type D, the upper and lower holes must be
used for installation. The middle holes remain free.
1
2
3
Installation Instructions and Instructions for Use
16
Subject to technical modifications. – Date of Issue
September/2020
Wall bracket installation
You specified the number, form and type of brackets on purchasing the awning in
accordance with the size, the mounting base, the screw pull-out forces, the mounting
material and the wind resistance classes. Recommendations can be found in our awnings
price list and the product-related calculation tables.
Before starting the installation, please check whether the details you gave
in your order concerning the mounting base comply with the given
mounting base. In case of doubt, please obtain information from a
specialist shop or a structural engineer.
If there are any discrepancies that could jeopardise the safety, the
installation must not be carried out. The wind class given may need to be
reduced.
Mark the position of the brackets (2) correspondingly:
- Determine the position for the holes of the fastening screws
(measure, adjust, mark).
- The brackets must not protrude over the awning (see next page).
- Drill holes, align and affix brackets.
Please observe the maximum allowable offset (± cm).
- Check the alignment of the brackets by means of a level or a plumb
line. The brackets must be on the same level both horizontally and
vertically.
Irregularities of the mounting base must be compensated accordingly in
order to install the cassette free of tension.
- Observe the torque indications of the anchor manufacturer when
tightening the screws. Please note, that the bore hole geometry is
decisive for the load-bearing capacity of an anchor.
- All elongated holes defined in the bracket must be used for fastening.
Legend
Distance between the
tensioning brackets
Wall bracket type B
1
2
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
17
Wall bracket installation
Check the mounting base and determine the appropriate mounting
material taking into account the mounting base and the fixing devices.
Information on the pull-out forces can be found in the documents in force.
Fix the brackets to the mounting base in accordance with the working
guidelines.
The brackets may not protrude over the awning. The minimum distance (5)
from the complete width to the outer edge of the bracket is 60 mm.
Therefore the wall bracket type B is installed off centre up to a B/C
dimension of 150 mm. For the wall bracket type D, this applies to a B/C
dimension of 300 mm.
Please note:
For models with an emergency hand crank, it may also be
necessary to mount the console out of the way for larger B / C dimensions.
Check the position before mounting on its drive side!
Legend
Arm bearing
Wall bracket type D
Distance between the tensioning brackets
Complete width
Minimum distance of 60 mm
for NHK 100 mm (on the drive side)
1
2
3
4
5
Installation Instructions and Instructions for Use
18
Subject to technical modifications. – Date of Issue
September/2020
Wall bracket installation
By means of the adjusting washers irregularities of the wall can be
compensated.
By turning the adjusting washer (5) the bracket (1) can be aligned on the
wall. The adjusting washers must be adjusted prior to attaching and
tightening the bracket.
Legend
Bracket
Plain washer
Nut
Fixing material
Adjusting disc
Adjusting discs are only delivered in conjunction with assembly set 2.
Note!
The adjusting washer must not be used in combination with an anchor bolt
(expansion anchor e.g. FAZ II).
1
2
3
4
5
1
5
