Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
35
Awning installation modular
Note!
Check again whether the brackets are positioned on the arm bearings. If
the arm bearing position does not coincide with the bracket position, the
static load bearing capacity is not available.
Maximum offset between arm bearing and bracket is limited by tension
pins in the brackets. The clamping part must not be clamped on the
clamping pins!
Screw the clamping piece (1) into the arm bearing (3) from the bottom.
After tightening the two fastening screws (2) the arm bearing (3) is firmly
connected to the bracket (6). The fastening screws must be tightened
reciprocally with 8Nm.
Legend
Clamping piece
Arm bearing
Bracket
Fastening screw DIN
912 M6x20 with
precote 30
View from the bottom
Clamping pin
Allen key A/F 5
1
5
6
4
2
3
7
Installation Instructions and Instructions for Use
36
Subject to technical modifications. – Date of Issue
September/2020
Awning installation modular
In order to facilitate the following steps, the arm sleeves (2) on the folding
arms (1) must be slightly pulled towards the middle. This way the front rail
is slightly moved towards the front.
Legend
Folding arms
Arm sleeves
The articulated arms are under high mechanical stress. With the lower
modular group they are secured by means of arm sleeves. When
removing the sleeves this potential energy discharges. There is a danger
to life.
Note!
The arm sleeves must not be removed prematurely under any
circumstances! The following assembly order must be observed. There is
a high risk of injury and danger to life!
1
2
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
37
Awning installation modular
Suspend the upper modular assembly, as shown, in the bracket. A part of
the profiles of both assemblies engage with each other (see illustration on
the following page).
The upper and lower modular assembly must line up precisely after
suspension.
Legend
Upper modular assembly
Bracket
1
2
Installation Instructions and Instructions for Use
38
Subject to technical modifications. – Date of Issue
September/2020
Awning installation modular
Check the joint of the upper and lower modular assembly as per detail (3)
again.
Legend
Coupling screw DIN 912 M6x120
Allen key A/F 5
Detail: Joint of the upper / lower modular assembly
Screw channel
Insert the coupling screws, as shown, into the screw channel (4) of the
upper modular assembly and screw them in.
The clamping screws must be tightened by hand!
Attention!
If the clamping screw is overtightened, the screw channel will be
damaged. After that, the feature cannot be used anymore.
1
2
3
4
