HEIDENHAIN TNC 426, User Manual

Page: 457 / 502

HEIDENHAIN TNC 426, TNC 430 431
12.5 Ether
n
et Int
e
rf
ace
Displaying the error log
U Press the SHOW ERROR soft key if you would like to see the error
log. Here the TNC records all errors that have occurred in the
network since the TNC was last switched on.
The listed error messages are divided into two categories:
Warnings are indicated with (W). Warnings occur when the TNC was
able to establish the network connection, but had to correct settings
in order to do so.
Error messages are indicated with (E). Error messages occur when the
TNC was unable to establish a network connection.
Error message Cause
LL: (W) CONNECTION xxxxx UNKNOWN USING DEFAULT
10BASET The name you entered in DEFINE NET, HW was
incorrect
LL: (E) PROTOCOL xxxxx UNKNOWN The name you entered in DEFINE NET, PROT was
incorrect
IP4: (E) INTERFACE NOT PRESENT The TNC was unable to find an Ethernet card.
IP4: (E) INTERNETADDRESS NOT VALID You used an invalid Internet address for the TNC.
IP4: (E) SUBNETMASK NOT VALID The SUBNET MASK does not match the Internet
address of the TNC.
IP4: (E) SUBNETMASK OR HOST ID NOT VALID You used an invalid Internet address for the TNC, or
you entered an incorrect SUBNET MASK, or you set
all of the HostID bits to 0 (1)
IP4: (E) SUBNETMASK OR SUBNET ID NOT VALID All bits of the SUBNET ID are 0 or 1
IP4: (E) DEFAULTROUTERADRESS NOT VALID You used an invalid Internet address for the router.
IP4: (E) CAN NOT USE DEFAULTROUTER The default router does not have the same net ID or
subnet ID as the TNC.
IP4: (E) I AM NOT A ROUTER You defined the TNC as a router.
MOUNT: <Device name> (E) DEVICENAME NOT VALID The device name is either too long or it contains
illegal characters.
MOUNT: <Device name> (E) DEVICENAME ALREADY ASSIGNED You have already defined a device with this name.
MOUNT: <Device name> (E) DEVICETABLE OVERFLOW You have attempted to connect more than seven
network drives to the TNC.
NFS2: <Device name> (W) READSIZE SMALLER THEN x SET TO x The value that you entered for DEFINE MOUNT, RS
is too small. The TNC sets RS to 512 bytes.
NFS2: <Device name> (W) READSIZE LARGER THEN x SET TO x The value that you entered for DEFINE MOUNT, RS
is too large. The TNC sets RS to 4096 bytes.
NFS2: <Device name> (W) WRITESIZE SMALLER THEN x SET TO x The value that you entered for DEFINE MOUNT, WS
is too small. The TNC sets WS to 512 bytes.