HEIDENHAIN TNC 426, User Manual

Page: 454 / 502

428 12 MOD Functions
12.5 Ether
n
et Int
e
rf
ace
Configuring the TNC
U In the Programming and Editing mode of operation, press the MOD
key. Enter the code word NET123. The TNC will then display the
main screen for network configuration.
General network settings
U Press the DEFINE NET soft key to enter the general network
settings and enter the following information:
Make sure that the person configuring your TNC is a
network specialist.
Setting Meaning
ADDRESS Address that your network manager must assign
to the TNC. Input: four decimal numbers
separated by points, e.g. 160.1.180.20
MASK The SUBNET MASK for expanding the number of
available addresses within your network. Input:
four decimal numbers separated by points. Ask
your network manager for the number of your
subnet mask, e.g. 255.255.0.0.
ROUTER Internet address of your default router. Enter the
Internet address only if your network consists of
several parts. Input: four decimal numbers
separated by points. Ask your network manager
for your address, e.g. 160.2.0.2.
PROT Definition of the transmission protocol.
RFC: Transmission protocol according to RFC 894
IEEE: Transmission protocol according to IEEE
802.2/802.3
HW Definition of the connection used
10BASET: for use of 10BaseT
HOST Name, under which the TNC identifies itself in the
network. If you are using a host name, you must
enter the “Fully Qualified Hostname” here. If you
do not enter a name here, the TNC uses the so-
called null authentication. The UID, GID, DCM and
FCM settings specific to the device (see next
page), are then ignored by the TNC.